- Out-of-Stock
-
MenuBack
- Heim
-
Shop
-
-
Electronics
-
Coin Doors
-
-
illumination
-
Mods
-
Multi-Game-Boards
-
-
circuit boards
-
Plunger
-
-
Control
-
-
Configurator
NEW
-
-
Description
Here you can assemble the Williams ball launcher according to your wishes.
This configurator is WITHOUT holder for virtual pinball.
-
Williams Kugelabschuss Configurator
-
-
-
Description
Here you can assemble the Williams ball launcher according to your wishes.
This configurator is WITH holder for virtual pinball.
-
Williams Ball Launch Configurator Complete Set
-
-
VGA video amplifier
The autonomous video amplifier converts the 1-volt output signal of common graphics cards into a 5-volt RGB signal, which is what many arcade monitors need to control.
The autonomous video amplifier converts the 1-volt output signal of common graphics cards into a 5-volt RGB signal, which is what many arcade monitors need to control. The module pulls out the required 5 volts for signal amplification from pin 9 of the VGA connector of newer graphics cards. For older graphics cards, where this is not possible, the module must also be connected to a 5 volt power source, which is a separate soldering point on the board.
Data sheet
- Weight
- 0,025 kg
Your review appreciation cannot be sent
Report comment
Report sent
Your report cannot be sent
Write your review
Review sent
Your review cannot be sent